Cessna 175 Skylark

175 Skylark
Cessna 175A Skylark
General information
Type	Light utility aircraft
Manufacturer	Cessna Aircraft Company
Number built	2,106
History
Manufactured	1958–1962
Introduction date	1958
First flight	April 23, 1956
Developed from	Cessna 172
Variants	Cessna T-41 Mescalero

The Cessna 175 is a light four-seat, single-engine, fixed wing aircraft produced by Cessna between 1958 and 1962. A deluxe model known as the Skylark was introduced in 1959 for the 1960 model year. The aircraft is similar to the popular Cessna 172 but has higher gross weight and a more powerful engine with a geared reduction drive.

Declining sales stemming from reputedly poor engine reliability prompted Cessna to drop the 175 and Skylark nameplates, but the company continued to produce aircraft based on the 175 for several decades, selling them as variants of the 172 and as a military trainer aircraft, the T-41 Mescalero.

The Cessna 175 is nearly identical on the exterior to the Cessna 172, and used the same engine as on early versions of the model, however that engine had a higher output, and by using the gear reducer, it achieved higher performance then it. The Cessna 175 sat in between the Cessna 172 and larger Cessna 182 in the product line at its debut.

Production history

The 175 was designed to fill a niche between the Cessna 172 and the slightly heavier, larger and faster Cessna 182. The engine of the 175, a reduction drive or geared version of the O-300 (Continental GO-300) used in the 172, is rated at 175 hp (130 kW), or 30 hp (22 kW) more than the engine offered in the contemporary 172. Between 1958 and 1962, a total of 2,106 were built. The basic airplane was marketed as the 175, and the plane with a package of optional equipment and overall paint (a partial paint scheme was used on the basic model) was marketed as the Skylark.

Design

Cessna 175 taxiing at Frederick Municipal Airport, Maryland, USA

The airframe of the 175 is all metal, constructed of aluminum alloy. The fuselage is a semi-monocoque structure, with exterior skin sheets riveted to formers and longerons. The strut-braced high wings are constructed of exterior skins riveted to spars and ribs. The 175 has fixed landing gear in a tricycle arrangement, with main gear legs made of spring steel, and a steerable nosewheel connected through an oleo strut for shock absorption.

While it incorporates airframe changes to accommodate an increased gross weight, the 175 is similar in appearance to the 172 of the same vintage. The main design change was the introduction of a stepped firewall in the 175, allowing the use of a longer cowl with larger air intakes, increasing airflow for improved engine cooling. The firewall was mounted further back in the fuselage than in the 172, and Cessna in turn relocated the instrument panel rearward into a wider section of the fuselage, allowing it to be enlarged and laid out differently than the 172 instrument panel. With the 1960 introduction of the 175A, Cessna introduced a swept-back vertical fin shared with the 172, along with a distinct engine cowling hump that serves as the most distinct external 175 spotting feature. Cessna also fitted the 175's stepped firewall and enlarged, relocated instrument panel to the 172 starting with the 172B model.

Cessna 175 floatplane

The other significant internal change from the 172 is a structural redesign of the inner third of the wings, allowing the installation of larger fuel tanks that hold 52 US gallons (200 L; 43 imp gal) versus 42 US gallons (160 L; 35 imp gal) in the 172; however, due to the location of the fuel pickups, only 42 gallons is usable in all flight conditions, and Cessna advised that only 167 hp (125 kW) may be available at the 175's best angle of climb.

Although externally identical to the 172 with most parts aft of the firewall being interchangeable, the 175 was built to a different type certificate. The P172D and R172 series (including the T-41B/C/D Mescalero) share the 175 type certificate, along with the 172RG, the retractable landing gear version of the 172.

The GO-300 engine

An unusual feature of the 175 is the geared GO-300 engine. Whereas most single-engine airplanes use direct drive, this engine drives the propeller through a reduction drive, so the engine runs at 3200 rpm to turn the propeller at 2400 rpm (4:3). The GO-300 engine suffered reliability problems and helped give the 175 a poor reputation. Some Skylarks flying today have been converted to larger-displacement direct-drive engines though almost 90% still retain the GO-300.

The GO-300's tainted reputation is largely undeserved, since its problems were the result of pilots who were unfamiliar with gear reduction engines, simply not operating the engine at the higher RPMs specified in the C-175 Pilot's Operating Handbook (POH). Pilots unfamiliar with the engine often operate the engine at the low RPM settings (2300–2700) appropriate to direct-drive engines, while the 175's Operating Handbook calls for cruising at 2900 RPM. The low RPM causes harmonic vibration in the reduction gear between the quill shaft (that turned the propeller) and crankshaft, and the low power results in low airspeeds that prevents the engine's air-cooling system from operating effectively, resulting in chronic reliability problems for engines not operated at the recommended power settings. Additionally, at 2500 RPM and below, the engine does not generate sufficient oil pressure for adequate lubrication and cooling. Provisions in the original POH may have contributed to pilot confusion and improper engine operation, as the POH lists cruise speed and fuel burn down to 2400 RPM or 36% power, creating the misleading impression that sustained operation at this RPM setting is safe. Pilots of the 175 are also advised to descend gradually at constant power settings and to always keep a load on the engine, as the reduction drives make it possible for airflow through the propeller to drive the engine at idle, which can result in engine damage.

Variants

For variants under the 175 type certificate but marketed as the Cessna 172, see Cessna 172 § Variants under 175 type certificate.

Cessna has historically used model years similar to U.S. auto manufacturers, with sales of new models typically starting a few months prior to the actual calendar year.

Cessna 175A Skylark at Rockcliffe Airport, Ontario, 2004

Cessna 175C at Sywell Aerodrome, Northamptonshire, UK. 2017

175

Introduced for the 1958 model year with a geared 175 hp (130 kW) Continental GO-300-A or -300-C engine with a shock-mounted cowling. Other differences from the 172 include a one-piece "Sight-Sweep" windshield and a gross weight of 2,350 lb (1,066 kg). Standard equipment included adjustable front seats, electric gauges, panel-mounted fuel drain control, safety-designed control wheels, and stainless steel mufflers. Optional wheel fairings were also available. The 1959 model year introduced new control wheels and was available in seven paint schemes (up from four in 1958), but was otherwise identical to the previous model year. Certified 14 January 1958. 702 (1958) and 536 (1959) built.

175A

1960 model year with a redesigned swept tail, a 175 hp (130 kW) Continental GO-300-A, -300-C, or -300-D engine, an external baggage door, and reduced nose geat oleo strut travel. This model was approved for seaplane operations with a gross weight of 2,450 lb (1,111 kg). A deluxe model was introduced under the name Slylark with a higher empty weight, full exterior paint, a refined interior, and wheel fairings as standard. Certified 28 August 1959. 540 built.

175B

1961 model year with an electric starter, a "Blend-Temp" ventilation system, "Polycloud" seat lining, and optional reclining front seats. The deluxe Skylark also featured an engine-driven vacuum system for the gyroscopic flight instruments. Like the 175A, the 175B was approved for seaplane operations. Certified 14 June 1960. 225 built.

175C Skylark

1962 model year with a 175 hp (130 kW) Continental GO-300-A or -300-E engine, new wingtip fairings with position lights, a revised cowling with cowl flaps, a dual-beam landing/taxi light on the left wing, a new two-bladed constant-speed propeller, and gross weight increased to 2,450 lb (1,111 kg). The baseline model was dropped for this model year, therefore all 175Cs carried the "Skylark" name. Certified 18 September 1961. 117 built. This was the last model to carry the model number 175, though future variants of the same type certificate were marketed as variants of the Cessna 172.

Specifications (Cessna 175C)

3-view line drawing of the Cessna 175

Data from Jane's All the World's Aircraft 1962–63

General characteristics

• Crew: 1
• Capacity: 3 passengers
• Length: 26 ft 6 in (8.08 m)
• Wingspan: 36 ft 2 in (11.02 m)
• Height: 8 ft 11 in (2.72 m)
• Wing area: 175 sq ft (16.3 m²)
• Aspect ratio: 7.52:1
• Airfoil: NACA 2412
• Empty weight: 1,410 lb (640 kg)
• Max takeoff weight: 2,450 lb (1,111 kg)
• Fuel capacity: 52 US gal (43 imp gal; 200 L)
• Powerplant: 1 × Continental GO-300-E air-cooled flat-six engine, 175 hp (130 kW)

Performance

• Maximum speed: 150 mph (240 km/h, 130 kn) at sea level
• Cruise speed: 104 mph (167 km/h, 90 kn) (economy cruise)
• Stall speed: 55 mph (89 km/h, 48 kn) (flaps extended)
• Range: 720 mi (1,160 km, 630 nmi) at economy cruise, no reserves
• Service ceiling: 17,800 ft (5,400 m)
• Rate of climb: 950 ft/min (4.8 m/s)
• Take-off run to 50 ft (15 m): 1,205 ft (367 m)
• Landing distance from 50 ft (15 m): 1,200 ft (370 m)

See also

• Skylark (disambiguation)

Related development

• Cessna 172
• Cessna 182 Skylane

References

• Taylor, John W. R., ed. (1962). Jane's All the World's Aircraft 1962–63. Sampson Low, Marston & Company, Ltd.

External links

• Media related to Cessna 175 Skylark at Wikimedia Commons